1. |
Input Voltage |
X |
Nominal Input Voltage |
Input Voltage Range |
1 |
110 VAC Single Phase |
90 – 132 VAC |
2 |
230 VAC Single Phase |
180 – 264 VAC |
12 |
110/230 VAC Switchable Single Phase |
90-132 / 180 - 264 VAC |
|
2. |
Frequency |
: 47-63 Hz |
3. |
Input |
: Through 3 core cable and 15 A 3 pin plug provided on the side of
Battery Charger. |
4. |
Battery Charger ON/OFF Switch |
: 16 Amp rating Rocker Switch with Neon Indicating lamp Provided
on the Front Panel. |
5. |
Battery Charging Voltage
(1) Auto mode
(2) Manual mode |
: (1) 4.9 V+/- 0.2V in Boost & Absorption mode
Boost voltage fine adjustment through preset on the front panel.
Adjustment range 4.7Vto 4.9V.
: (2) 4.5 V +/- 0.2V in Float mode
Float voltage fine adjustment through preset on the front panel.
Adjustment range 4.35 V to 4.7 V.
: (1) Continuously adjustable from 3.6 V+/- 0. 2V to 5.0 V+/- 0.2 V
through multiturn pot.
|
6. |
Current Ratings
Code YYYA |
100 Amps Max |
160 Amps Max |
200 Amps Max |
240 Amps Max |
100A |
160A |
200A |
240A |
|
7. |
Charging Current |
: Maximum charging current can be Adjusted from 10 % to 100 % of
Current rating with multiturn pot. Maximum charging current limit
should be set as per battery capacity. |
8. |
Battery Switch |
MCB 40A,
2 pole |
MCB 63A,
2 pole |
MCB 50A,
3 pole |
MCB 63A,
3 pole |
|
9. |
Protections |
: Battery Charger protected against Over Load, Short Circuit, Over Voltage,
Over Temperature & Reverse Input. |
10. |
Display
Voltmeter
Current Meter |
3 1/2 Digit DPM for displaying Battery / Charger voltage (in volts).
Accuracy 0.2V +/- 2 digits |
3 1/2 Digit DPM for displaying charging current (in Amp).
Accuracy 0.2A +/- 2 digits |
4 1/2 Digit DPM for displaying charging current (in Amp).
Accuracy 0.2A +/- 2 digits |
|
11. |
Battery Connector |
Bus bar with 5/16” threaded STUD, 1 each for +ve & -ve |
|
12. |
Charging Stages
|
: Boost charge
: Absorption charge
: Float charge |
13. |
Indications |
: Red LED for Boost stage
: Yellow LED for Absorption stage
: Green LED for Float stage (Indicating Battery is fully charged )
: Red LED to indicate Reverse Battery Connection.
: Green LED each for Manual & Auto Mode. |
14. |
Enclosure |
: IP 20. |
15. |
Mounting |
: Provision for Table top and wall / Panel mounting. |
16. |
Size |
: 320(W) x 350(H) x 150(D) MM |
17. |
Weight |
: 13 Kg. |
